Date: Fri, 25 May 2007 13:54:49 +0200 (CEST) From: Stefan Richter Subject: [rfc patch] firewire: prefix modules with firewire- instead of fw- Of course everybody immediately associates "fw-" with FireWire, not firmware or firewall or whatever. But "firewire-" has a nice ring to it too. Signed-off-by: Stefan Richter Acked-by: Kristian Hoegsberg --- drivers/firewire/Kconfig | 14 +++++++------- drivers/firewire/Makefile | 12 +++++++----- 2 files changed, 14 insertions(+), 12 deletions(-) Index: linux/drivers/firewire/Kconfig =================================================================== --- linux.orig/drivers/firewire/Kconfig +++ linux/drivers/firewire/Kconfig @@ -18,7 +18,7 @@ config FIREWIRE your IEEE 1394 adapter. To compile this driver as a module, say M here: the module will be - called fw-core. + called firewire-core. This is the "JUJU" FireWire stack, an alternative implementation designed for robustness and simplicity. You can build either this @@ -34,11 +34,11 @@ config FIREWIRE_OHCI is the only chipset in use, so say Y here. To compile this driver as a module, say M here: The module will be - called fw-ohci. + called firewire-ohci. If you also build ohci1394 of the classic IEEE 1394 driver stack, - blacklist either ohci1394 or fw-ohci to let hotplug load the desired - driver. + blacklist either ohci1394 or firewire-ohci to let hotplug load the + desired driver. config FIREWIRE_SBP2 tristate "Support for storage devices (SBP-2 protocol driver)" @@ -50,12 +50,12 @@ config FIREWIRE_SBP2 like scanners. To compile this driver as a module, say M here: The module will be - called fw-sbp2. + called firewire-sbp2. You should also enable support for disks, CD-ROMs, etc. in the SCSI configuration section. If you also build sbp2 of the classic IEEE 1394 driver stack, - blacklist either sbp2 or fw-sbp2 to let hotplug load the desired - driver. + blacklist either sbp2 or firewire-sbp2 to let hotplug load the + desired driver. Index: linux/drivers/firewire/Makefile =================================================================== --- linux.orig/drivers/firewire/Makefile +++ linux/drivers/firewire/Makefile @@ -2,9 +2,11 @@ # Makefile for the Linux IEEE 1394 implementation # -fw-core-y += fw-card.o fw-topology.o fw-transaction.o fw-iso.o \ - fw-device.o fw-cdev.o +firewire-core-y += fw-card.o fw-topology.o fw-transaction.o fw-iso.o \ + fw-device.o fw-cdev.o +firewire-ohci-y += fw-ohci.o +firewire-sbp2-y += fw-sbp2.o -obj-$(CONFIG_FIREWIRE) += fw-core.o -obj-$(CONFIG_FIREWIRE_OHCI) += fw-ohci.o -obj-$(CONFIG_FIREWIRE_SBP2) += fw-sbp2.o +obj-$(CONFIG_FIREWIRE) += firewire-core.o +obj-$(CONFIG_FIREWIRE_OHCI) += firewire-ohci.o +obj-$(CONFIG_FIREWIRE_SBP2) += firewire-sbp2.o