Date: Sat, 14 Jun 2008 14:24:53 +0200 (CEST) From: Stefan Richter Subject: firewire: Kconfig menu touch-up Emphasize the recommendation to build only one stack. Trim the prompts to better fit into short attention spans. Signed-off-by: Stefan Richter --- drivers/firewire/Kconfig | 32 +++++++++++++++----------------- 1 file changed, 15 insertions(+), 17 deletions(-) Index: linux/drivers/firewire/Kconfig =================================================================== --- linux.orig/drivers/firewire/Kconfig +++ linux/drivers/firewire/Kconfig @@ -1,28 +1,26 @@ -comment "An alternative FireWire stack is available with EXPERIMENTAL=y" +comment "A new alternative FireWire stack is available with EXPERIMENTAL=y" depends on EXPERIMENTAL=n +comment "Enable only one of the two stacks, unless you know what you are doing" + depends on EXPERIMENTAL + config FIREWIRE - tristate "IEEE 1394 (FireWire) support - alternative stack, EXPERIMENTAL" + tristate "New FireWire stack, EXPERIMENTAL" depends on EXPERIMENTAL select CRC_ITU_T help This is the "Juju" FireWire stack, a new alternative implementation designed for robustness and simplicity. You can build either this - stack, or the classic stack (the ieee1394 driver, ohci1394 etc.) - or both. Please read http://wiki.linux1394.org/JujuMigration before - you enable the new stack. + stack, or the old stack (the ieee1394 driver, ohci1394 etc.) or both. + Please read http://wiki.linux1394.org/JujuMigration before you + enable the new stack. To compile this driver as a module, say M here: the module will be called firewire-core. It functionally replaces ieee1394, raw1394, and video1394. - NOTE: - - You should only build ONE of the stacks, unless you REALLY know what - you are doing. - config FIREWIRE_OHCI - tristate "Support for OHCI FireWire host controllers" + tristate "OHCI-1394 controllers" depends on PCI && FIREWIRE help Enable this driver if you have a FireWire controller based @@ -33,12 +31,12 @@ config FIREWIRE_OHCI called firewire-ohci. It replaces ohci1394 of the classic IEEE 1394 stack. - NOTE: + NOTE: - You should only build ohci1394 or firewire-ohci, but not both. - If you nevertheless want to install both, you should configure them - only as modules and blacklist the driver(s) which you don't want to - have auto-loaded. Add either + You should only build either firewire-ohci or the old ohci1394 driver, + but not both. If you nevertheless want to install both, you should + configure them only as modules and blacklist the driver(s) which you + don't want to have auto-loaded. Add either blacklist firewire-ohci or @@ -60,7 +58,7 @@ config FIREWIRE_OHCI_DEBUG default y config FIREWIRE_SBP2 - tristate "Support for storage devices (SBP-2 protocol driver)" + tristate "Storage devices (SBP-2 protocol)" depends on FIREWIRE && SCSI help This option enables you to use SBP-2 devices connected to a